Honda V 45 SABRE-VF750S 1982 Shop Manual page 157

•
CRANKCASE
Tighten the upper crankcase bolts to the specif ied
torque in a crisscross panern and in 2-3 steps.
TORQUE: 8 mm: 21-25 N.m
NOTE :
(2.1-2.5 kg-m. 15-18 ft-Ibl
6
mm:
10-14 N·m
11.0-1.4 kg-m, 7-10 ft-Ibl
Make
$url
that the plain washers are under the
bolt heads of the thr" crankcase mounting
bolts shown.
InSlall the mainshaft bearing holder and tighten the
screw and bolt .
fnstall a new output gear case gasket with one of
the same thickness as remol/ed .
NOTE :
If the gasket was not measured during dis-
assembly, refer to page 13-6 for gasket
selection procedures.
Early production engines had gaskets that
were not marked.
The gasket Is crushed O.OS mm when the
output gear case is installed .
Innall the output gear case with. new gasket.
Install the bolts and sealing washers and then
lighten to the specified torQue.
TORaUES:
Output gear case
bluing Ilokter bolts: 30-34 N·m
(3.0-3.4 ka-m. 22-25 ft·lb)
8 mm boh,/socket bolts: 21-25 N·m
{Z.1-Z.S kg·m, 14-18 ft·lbl
6 mm bolts: 10-14 N·m (1.0-1.4 kll·m. 7-10 ft·lbl
11-6
r.;}\ HONDA
~ V45 ~~:::
8
mm
AND AND
PLAIN WASHERS PLAIN WASHERS
MAIN'SHAFT
.!:!OL~
OUTPUT GEAR CASE
BOLTS
6
mm BGILl
ANDWASHEA
8
mm
SO,Ci<:ET
BOLT
,
. .
Date of Issue: May, 198Z
©
HONDA MOTOR CO ., lTD .
- - -
-
-