Transmission - Honda V 45 SABRE-VF750S 1982 Shop Manual

-
-
13. TRANSMISSION
SERVICE INFORMATION
13- 1 OUTPUT GEAR CASE GASKET
TROUBLESHOOTING 13-2
SELECTION 13- 16
TRANSMISSION DISASSEMBLY 13-3
COUNTERSHAFT INSPECTION
13- 18
OUTPUT DRIVEN GEAR
SHIFT FORK AND SHIFT DRUM
13- 19
REMOVAL
13- 9 TRANSMISSION ASSEMBLY
13- 22
GEAR TOOTH CONTACT
COUNTERSHAFT 13- 23
PATTERN CHECK 13- 14
SERVICE INFDRMATION
GENERAL
• The gearshaft linkage can be serviced with the engine in the frame (Section 8),
• For internal transmission repairs, the crankcase must be separated (Section 11).
• Replace the countershaft and output driven gear 15 a set.
• When using the lock nut wrench, use I deflecting beam type torque wrench 14·20 inches long, T he lock nu t wrench in·
creases the torque wrenche's leverage. so the torque wrench reading will be less t han t he torque actuallv applied to the loci<.
nut The specification given
IS
the act ual torque appl ied to the lock nut, not the reading on the torque wrench when used
With the lock nut wrench. The torQue wrenCh scale
reading is given with the act ual torque specjf jcation.
SPE CI FI CA T :..: I ..:O-,-Nc:S _ _ _
Transmission Backlash
Gear bushing
0.0.
Gear bu$hing
1.0.
0.0.
Gear·to-bushing
or shaft
Date
o f Issue:
October, 1982
() HONOA MOTOR CO., LT D .
-
low
C4
M5
Cl
C4
go"
M5 bushing to shaft
---
in)
mm
24 .90 mm
mm 0 .10 mm (0 .004
in)
mm
(0 .0002- 0 .0019
(0 .002
in)
'"
13-1