Switches - Honda V 45 SABRE-VF750S 1982 Shop Manual

-
-
-
-
-
-
CJ\ HONDA
® V45
~~:::
SERVICE INFORMATION
01 L PRESSURE SWITCH
BRAKE LIGHT SWITCH
GEAR CHANGE SWITCH
HANDLEBAR SWITCHES
IGNITION SWITCH
CLUTCH SWITCH
FUEL LEVEL SENSOR (V45 SABRE)
LOW FUEL WARNING LIGHT
(V45 MAGNA)
FUEL PUMP (V45 MAGNA)
THERMOSTATIC SWITCH
TEMPERATURE SENSOR
SERVICE INFORMA nON
GENERAL
21-1
21-2
21-2
21-3
21-4
21~
21~
21~
21-8
21-8
21-9
21-9
,
21. SWITCHES
TEMPERATURE GAUGE
21 - 11
RAOIATOR RESERVOIR SENSOR 21-11
SPEED SENSOR (V45 SABRE) 21-11
TRIP METER (V45 SABRE)
21-12
SPEEDOMETER (V45 SABRE) 21-12
TACHOMETER 21-12
CLOCK (V45 SABRE)
21-13
BRAKE AND TAIL LIGHT SENSOR 21-14
HEADLIGHT SENSOR (V45 SABRE)
21-14
BATTERY ELECTROLYTE LEVEL
SENSOR (V45 SABRE)
21-15
TURN SIGNAL CANCEL SYSTEM
(V45 SABRE)
21-16
• Some wires nave different colored bands around them near the connector. These are connected to other wires which cor-
respond with the band color.
• AU plastic plugs have tocking tabs thlt must be released before disconnecting, and must be aligned when reconnecting.
• The follow ing color codes
u~
are indicated throughout this section and on the wiring diagram.
B - Blue
Bk - Black
Sr .. Brown
G - GrHn
Gr - Grey
LB .. Ught Blue
LG - light Green
o -
O,ange
P .. Pink
R - Red
W - Whit.
Y .. Yellow
• To isolate an electrical failure, check the continuity of the electrical path through the part. A continuity check can usuallv
be made without remOlling the part from the motorcycle. Simply disconnect the wires and connect a continuity tester or
lIolt-ohmmeter to the terminals or connections.
• A continuity tester is useful when checking to find out whether or not there is an electrical connection between the two
points. An ohmmeter is needed to measure the resistance of a circuit, such as when there is a specific coil resistance inllolll-
ed, or when checking for high fllSistance caused by corroded connections.
Date of Issue : October, 1982
© HONDA MOTOR CO .. LTD.
329
21-1
1