Engine Oil Level; Engine Oil & Filter Change - Honda V 45 SABRE-VF750S 1982 Shop Manual

•
-
~
. .
~
HONDA
'\t,
V45
SABRE
. MAGNA
ENGINE OIL LEVEL
Check engine oil level before operating the motor-
cycle. Put the motorcycle on its center stand on
level ground. Check the oil level at the engine oil
inspection window on the right side cover.
Clean the oil inspection window on the right side
cover with the wiper.
If tho level is below the tower level mark on the
inspection window, remove the filler cap and fill
to the upper level mark.
Check the oil pressure with the warning indicator
switch after the engine starts, The indicator should
go off after one or two seconds.
If it does not, check the oil pump function and/or
oil circuit.
ENGINE OIL & FILTER CHANGE
NOTE:
Change engine oil with the engine warm and
the motorcvcle on its center stand to assure
complete and rapid draining.
Stop the engine.
Remove the oil filler cap, cylinder head oil drain
plug, engine bottom oil drain plug and drain the oi1.
Remove the oil filter with a filter wrench and let the
remaining oil drain out. Discard the oil filter.
Make sure that the sealing washers on the drain
plugs are in good condition and install the plugs.
After completely draining the oil replace the oil
filter with a new one. Coat the oil filter seal With oil.
Fill the crankcase with 2.9 liters (3.1 US qt, 2.5 Imp
qt) o f the recommended oil (page 2· 1).
Start the engine and let it id le for 2-3 minutes,
then stop the engine.
Make sure that the oil level is at the upper level
mark in the inspection window.
Make sure that there are no oil leaks.
Date of Issue: May, 1982
© HONDA MOTOR CO .. LTD .
-
Oil FilTER 15- 20 N·m
(1.5-2.0 kg·m, 1 1 - 14 ft -Ib)
DRAIN PLUG 35- 40 N·m
(3_5-4.0 kg-m, 25- 29 ft-I b)
11
LUBRICATION
CYLINDER L DRAIN PLUG
10-14 N-m (1.0- 1.4
kg-m,
7-10
ft-Ib)
2-3
•
,