Gear Box; Gear Box Cover - MOTO GUZZI V-7 700 Operating Handbook

- cush drive spring.
- sliding muff.
- clutch shaft to mainshatt driving gear.
Note : To remove the above parts from clutch
shaft it is necessary to position the shaft
on a pressing machine and after having
fitted tool No. 12905900 (see 23 on Fig . 78) .
press down enough to remove the two se-
micollars from shaft groove.
Further parts to be removed are :
neutral indicato r unit (see A on Fig . 77).
Filler plug and drain plug (B and A on Fig .
75).
- Seal in gear box, for clutch shaft.
- Seal, in box cover, for layshafl.
GEAR BOX
Remove from gearbox the following parts :
Ball bearing for layshaft, using puller No.
12913700 (see 8 on Fig. 79) .
Roller bearing for mains haft, using puller No.
12913100 (see 9 on Fig. 80) .
Ball bearing for clutch shaft, by means of
round punch .
GEAR BOX COVER
Remove:
- Ball bearings for mainshaft and clutch shaft,
using puller No. 12907000 (see 10 on Fig.
81 - 82).
- Ball bearing for layshaft, by means of round
punch .
Fig . 80
Fig. 81
Fig . 52
55