MOTO GUZZI V-7 700 Operating Handbook page 68

FRONT SUSPENSION AND
STEERING
STRIPPI NG
To strip down handlebar, front fork and stee-
ring operate as follows :
- remove handlebar, after disconnecting con-
trol cables, undo clamp screws and remove
clamp caps.
- undo screws which secure instrument panel,
disconnect electric cables and speedo drive
from speedometer.
remove instrument panel , after removal of
the 4 screws which secure same to fork top
linking plate.
remove speedometer from Instrument panel.
- from top linking plate remove nut and fork
top plugs.
- remove top linking plate, by means of ring
wrench and tool No. 60910500 (see 3 on
Fig . 96).
66
remove steering lube lockring (8) and lock
cap (A) as shown on Fig. 97.
undo bolts securing bottom yoke to fork
rods.
remove bottom fork covers c/ w fork rods and
spring housings, avoiding to spill the oil
contained inside.
Fig. 96
Fig. 97
- drain oil from dampers (after stripping down
fork , oil can be drained by removing drain
plugs (see A on Fig. 98) from both fork
covers).
Fig . 98