Removal Of - MOTO GUZZI V-7 700 Operating Handbook

REMOVAL OF " ENGINE·GEARBOX» GROUP FROM FRAME
(see Fig. 6)
For the removal of the .. engine·gearbox,. group
from frame" remove the following:
battery covers (UH & RlH) and disconnect
cab les from battery.
speedo control cable from transmission in
gearbox.
saddle, fuel tank and battery , after remo val of
holder bracket.
throttle and air cables two-ways adapter,
without disconnecting cables.
battery support plate, clutch control cable
from lever on gearbox, starter control electric
cables and neutral indicator cable from gear-
box.
coil, after disconnnecting electric cables; dis-
tributor cap, after disconnecting spark plugs
cables; distributor rotor.
generator covers; generator belt guard and
generator unit.
mufflers, large band on rubber gaiters.
Put engine on a support and after unscrewing
nuts extract bolts securing «engine·gearbox»
group to frame; move the group forward (towards
front wheel) tilting it to the right then extracting
it
from f rame.
N.B.: The above operation is suggested to be
carried out by two mechanicians.
After removal of group from frame, wash same
with petrol and dry by compressed air. Then
strip engine assy from gearbox assy.
11