MOTO GUZZI V-7 700 Operating Handbook page 16

rocker arm spindles, rocker arms, rocker arm
springs and washers (see Fig . 12). Remove
tappet adjusting screws after loosening nuts.
push rods.
rocker arms support , after unscrewing the four
long bolts and the two short bolts (each head)
which secure cylinder and cylinder head to
crankcase.
cylinder heads c/w valves and remove gasket.
Using tool No. 60907200 (see 7 on Fig . 13) re-
move from cylinder head the semlcones, top
collars, springs, bottom collars and then ex-
tract valves from inside.
cylinders and relative gasket.
tappets from housing on crankcase.
piston pin , by means of puller No. 26907800
(see 17 on Fig . 14), after removal of circlips.
the piston and from same remove piston rings.
oil sump , after unscrewing screws securing
same to crankcase. Also remove oil sump
gasket.
oil pump, after removing screws securing sa-
me to crankcase. From pump remove key,
driven gear and driving shaft.
Fig. 12
Fig. 13
co mplete oil cleaner and gasket (see B on
Fig . 15). Cleaner consists of : 2 retaining bolts ,
bottom plate, wire gauze and cleane r body .
o il pipe (see A on Fig . 15), after flattening
lock plates and unscrewing securing bolts
and washers. Remove from pipe the pressure
r",! ief valve, cons isting of : plunger, spring ,
bottom plate and plug .
con-rod caps, after flattening lock plates and
unscrewing nuts. Then extract con-rods from
Fig. 14