MOTO GUZZI V-7 700 Operating Handbook page 120

INSTRUMENTS AND CONTROLS
, - Speedometer (See fig. 128) including:
a) Mile calibrated clock ;
b) High beam indicator red light;
c) Red warning light, ammeter. Indicating
insufficient flow of current from gene-
rator for battery charge. Should go out
when engine has reached a ceria in num-
ber of revolutions.
d) Orange warning light. Neutral indicator.
Does not light up when any gear is
engaged;
e) Red warning light. Oil pressure gauge.
Goes out when there is sufficient oil
pressure for engine lubrication.
IGNITION KEY •
An ignition key and a duplicate are supplied with
each machine. The number should be recorded.
In case of loss, the key number should be repor-
ted to your dealer.
2 - Ignition key switch (Automotive type). This
controls the entire electric equipment and
engine starting. This key has the function
of an antitheft device (See fig. 129).
II.
This key has four positions:
.. 0»
=
Machine at standstill. key remova
4
ble , ali electrics switched off.
Machine standing , key removable,
parking lights on.
«2"
=
Running position or machine ready
to set out. All controls on. For
daylight riding no other position is
necessary.
For night driving lever A on the left
handlebar switch must be switched
on.
«3"
=
For starting only. The key returns
automatically to position 2 when
the engine has started.
4
4
Dimmer switch and horn button (see fig. 8).
On left handlebar.
Switch A:
Position 1 lights off
Position
2 =
lights on
Switch B:
Position
3
=
low beam
Position
4 =
high beam
Push button C
=
horn control.
5
4
Twist grip throttle control
It is fitted on the right hand lebar. Throttle is
opened by turning towards the rider.
6 - Clutch lever
It is located on the Jeft hand handlebar and
should be used only for starting and gear
shifting.
7
4
Gearshift lever
Of rocking type, on right hand side of ma
4
chine.
8
4
It is located on the left hand side of the
machine.
4
Fig. 129