Table of Contents
Advertisement
Fig. 87
fit ball bearing on
fork,
securi ng it by
circlip.
now insert double joint in fork ball bearing
and fit gaiters over
joint,
securing them by
band on fork side only. Front side of gaiters
will be secured only when engine-gearbox
group will be assembled to
frame.
ASSEMBLING GEAR WHEEL DRIVE TO
R/
H
ARM OF REAR FORK
To assemble rear wheel drive to rear fork ope-
rate as follows (see Fig. 87):
62
after positioning circlips in drive shaft groo-
ves insert shaft into double joint and shaft
bevel drive
sleeve.
insert splined portion of bevel pinion (A) into
sleeve (8) and screw up without locking
the four bolts and washers (C) securing drive
box (E) to rear fork arm (D). Then insert
rear
wheel spindle (F) thru UH side arm of rear
fork and inside drive
box,
screw down the
four bolts (C) and extract spindle (F)
.
Finally, pour 0.300 It. (5/8 pi nts) of Shell Spi-
/ '
SHIM UP "",l!l
"'
£~
E
'" A CL EARAtKE
rF
.oQ)''''IO'<;\"
IN
K
IW
tE
N
GtMl~
Fig.
88
Advertisement
Table of Contents
