Gear Box Stripping - MOTO GUZZI V-7 700 Operating Handbook

pedal will shift to a higher gear, while pushing
back bar will shift to a lower one. Idle running
is between low gear and 2nd gear. To select
idle gear shift back to low gear and then push
front bar half way down.
GEAR BOX STRIPPING
Before beglning to strip down the gearbox
drain oil contained therein by unscrewing drain
plug (see Fig . 75) .
Remove the following:
- clutch operating lever
- rocker pedal
- speedometer cable
- layshaft lock ring by means of special
wrench No. 12905400 (see 5 on Fig . 76),
after having disengaged tab washer by
means of tool No. 12907100 (see 18 on Fig.
76) .
- layshaft spacer
- speedo drive gear
- selector cover,
c/w
shaft and sector, spring
and offset adjusting screw, by unscrewing
cover screws.
- gear box cover, after removal of the 10
sc rews securi ng same to gear box.
- clutch outer body , clutch cage and pressure
rod .
From inside gearbox remove now the following :
- clutch Inner body circlip and inner body
- oil
pick~ up
plate.
- breather plug, spring and pawl acting on
selector drum.
Fig . 75
..
.
,.
,
..
'
"",
.
!!~~
... ..
#
,....,.
..
'
"'
.'
...
Fig . 76
Fig. 76/1
53