MOTO GUZZI V-7 700 Operating Handbook page 73

BALL BEARINGS AND TAPER ROLLER
BEARINGS
Bearings must be in perfect condition, without
excessive slack. Races must be perfectly even
and smooth . Rollers and balls must be unim·
paired all over their surface. If any fault is
detected. bearing mu st be replaced (see para-
graph " Bearings " on page 77) .
FITTING UP REAR FORK
Fitting up is carried out as follows :
- press taper roller beari ngs in their housings.
- press in the two seal rings.
- posit ion spacers.
- fit fork on frame.
- insert support spindles.
- tighten locknuts allowing fork to swing
freely. Use special wrench No. 12903000 (see
13
on
Fig . 104) and open wrench to hold
locknut.
Fig. 104
71