MOTO GUZZI V-7 700 Operating Handbook page 49

Atomizer
Check periodically the condition of gauged part
entered by taper needle. It is best to have this
check made at a DELL'ORTO service station. tn
case of wear replace part with ORIGINAL of sa-
me size.
N.B.: Bear in mind that
correct
fuel consumption
is directly related to good condition of
taper needle and atomizer.
Main jet
Ensure that jet orifice is never tampered with in
order to alter setting and not cleaned with a wire
either, unless of much smaller size and tender
material. This for avoiding involuntary widening
of orifice which would in turn increase consump-
tion and upset ca rburation. In case of wear re-
place main jet with ORIGINAL part of same size.
Pilot jet
The same rules as above are valid also for pilot
jet.
Constant level float ch amber
Good operation of this carburetor part is essen-
tial for a correct carburation . Check periodIcally
the following parts:
A - Float needle
Ensure that tapered section of needle is in
perfect condition. In case of seizing marks
or wear replace it.
B - Float needle seal
Check that seat corner contacting needle is
not deteriorated or damaged. If so, replace it.
C -
Float
Ensure that float is not made heavier by pos-
sible gasoline seeping and that float needle
is perfectly secured.
Fuel filler
Check this filter often, clean it with pure gasoline
and dry it off by compressed air.
.,