MOTO GUZZI V-7 700 Operating Handbook page 89

ADJUSTMENT OF GENERATOR BELT TENSION
Generator belt might slacken with use and
slipping might then ensue. It is necessary there·
fore to check correct tension (see Fig . 11612).
Normal slack is 1 em. per 10 kgs. pressure
(.39"/21 Ibs). To obtain correct belt tension
proceed as follows:
- unscrew bolts (C) which secure the outer
half·pulley to the hub.
- remove outer half·pulley.
remove one or more adjusting collars, thus
reducing width of pulley race.
If more than one collar is removed, fit these
back at the front and rear end of the pulley.
Refit outer half·pulley tightening up the 3 secu·
ring bolts (C).
Fig. 116/2
87