Configuring High Availability Vlans On A Switch; Creating And Deleting Vlans - OmniSwitch os6900 Network Configuration Manual

Configuring High Availability VLANs on a Switch

Configuring High Availability VLANs on a Switch
This section describes how to use the Command Line Interface (CLI) commands to configure high avail-
ability (HA) VLANs on a switch. For a brief tutorial on configuring HA VLANs, see
Creating High Availability VLANs" on page
When configuring HA VLANs, you must perform the following steps:
1
Create a VLAN. To create a VLAN use the
Deleting VLANs" on page
2
Assign VLAN member ports. To assign member ports to the VLAN, use the
untagged command which is described in
page 4-7
3
Create a server cluster and configure the mode. To create a server cluster and configure the cluster
mode, use the server-cluster
Ports" on page 5-7
4
Assign MAC Addresses. To assign MAC addresses to the HA VLAN server cluster, use the
cluster mac-address
page 5-8.
Note. Use the show server-cluster
"Displaying High Availability VLAN Status" on page 5-16

Creating and Deleting VLANs

The following subsections describe how to create and delete a VLAN with the
Note. This section provides only a basic description of creating and deleting VLANs. For a complete
description of configuring and monitoring VLANs on a switch, please refer to
VLANs."
Creating a VLAN
To create a new VLAN use the
example, to create a VLAN with a VLAN ID number of 10 enter
-> vlan 10
You can also specify the administrative status and a name for the VLAN with the vlan command. For
example, to administratively enable (the default) a VLAN when you configure it enter vlan followed by
the VLAN ID number and enable.
For example, to create VLAN 10 and administratively enable it enter
-> vlan 10 enable
page 5-6
5-3.
5-6.
"Changing the Default VLAN Assignment for a Port" on
command which is described in
command, which is described in
command to verify the HA VLAN configuration on the switch. See
vlan command by entering vlan followed by the VLAN ID number. For
OmniSwitch AOS Release 7 Network Configuration Guide
Configuring High Availability VLANs
vlan command, which is described in
"Adding and Removing Server Cluster
"Assigning and Removing MAC Addresses" on
for more information.
"Quick Steps for
"Creating and
vlan members
server-
vlan command.
Chapter 4, "Configuring
June 2013