Configuring Shared Link - OmniSwitch os6900 Network Configuration Manual

Configuring ERP
The following sub-sections provide the details on prerequisites and different configurations for switches to
set up an ERPv2 ring network, using Alcatel-Lucent OmniSwitch CLI commands.

Configuring Shared Link

The following configurations must be performed on Switch A and Switch B.
Step 1 : Create the Service VLAN and add to ring ports on Switch A and B that are part of a shared link:
Switch A -> vlan 10
Switch A -> vlan 200
Switch A -> vlan 10 members port 2/1 tagged
Switch A -> vlan 10 members port 2/2 tagged
Switch A -> vlan 200 members port 1/6 tagged
Switch B -> vlan 10
Switch B -> vlan 200
Switch B -> vlan 10 members port 1/1 tagged
Switch B -> vlan 10 members port 2/2 tagged
Switch B -> vlan 200 members port 1/6 tagged
Step 2 : Create the ERP rings 1 and 2 on Switch A.
Switch A -> erp-ring 1 port1 2/1 port2 2/2 service-vlan 10 level 1
Switch A -> erp-ring 2 sub-ring-port 1/6 service-vlan 200 level 1
Step 3 : Create traffic VLANs and add to ring ports as necessary using VM commands on Switch A.
Switch A -> vlan 100-400
Switch A -> vlan 100-300 members port 2/1 tagged
Switch A -> vlan 100-300 members port 2/2 tagged
Switch A -> vlan 201-400 members port 1/6 tagged
Step 4 : Enable the rings on Switch A.
Switch A -> erp-ring 1 enable
Switch A -> erp-ring 2 enable
Configuring Main RPL Node
Main RPL is configured on the Switch B. The following configurations must be performed on Switch B.
Step 1 : Create the ERP rings 1 and 2 on Switch B.
Switch B -> erp-ring 1 port1 1/1 port2 2/2 service-vlan 10 level 1
Switch B -> erp-ring 2 sub-ring-port 1/6 service-vlan 2000 level 1
Step 2 : Configure Switch B as RPL Node using the erp-ring epl-node command:
Switch B -> erp-ring 1 epl-node 2/2
Step 3 : Enable the rings on Switch B.
Switch B -> erp-ring 1 enable
Switch B -> erp-ring 2 enable
OmniSwitch AOS Release 7 Network Configuration Guide
Sample ERPv2 Ring Configuration
June 2013 page 11-25