Enabling/Disabling A Port Mapping Session - OmniSwitch os6900 Network Configuration Manual

Enabling/Disabling a Port Mapping Session

Enabling/Disabling a Port Mapping Session
By default, the port mapping session is disabled. The following subsections describe how to enable and
disable the port mapping session with the
Enabling a Port Mapping Session
To enable a port mapping session, enter port-mapping followed by the session ID and enable.
For example, to enable the port mapping session 5, enter:
-> port-mapping 5 enable
Disabling a Port Mapping Session
To disable a port mapping session, enter port-mapping followed by the session ID and disable.
For example, to disable the port mapping session 5, enter:
-> port-mapping 5 disable
Disabling the Flooding of Unknown Unicast Traffic
By default, unknown unicast traffic is flooded to the user ports of a port mapping session from all the
switch ports. To disable this flooding and to receive traffic from only the network ports, enter:
-> port-mapping 5 unknown-unicast-flooding disable
Configuring a Port Mapping Direction
By default, port mapping sessions are bidirectional. The following subsections describe how to configure
and restore the directional mode of a port mapping session with the
rectional] command.
Configuring Unidirectional Port Mapping
To configure a unidirectional port mapping session, enter port-mapping followed by the session ID and
unidirectional keyword. For example, to configure the direction of a port mapping session 6 as
unidirectional, enter:
-> port-mapping 6 unidirectional
Restoring Bidirectional Port Mapping
To restore the direction of a port mapping session to its default (bidirectional), enter port-mapping
followed by the session ID and bidirectional keyword. For example, to restore the direction
(bidirectional) of the port mapping session 5, enter:
-> port-mapping 5 bidirectional
page 30-4
port-mapping command.
OmniSwitch AOS Release 7 Network Configuration Guide
Configuring Port Mapping
port-mapping [unidirectional | bidi-
June 2013