Policy Actions - OmniSwitch os6900 Network Configuration Manual

QoS Policy Overview
For specific information about how to configure policy conditions and actions to create a policy rule, see
"Creating Policies" on page

Policy Actions

The following actions are supported and can be combined with other actions.
Supported Policy Actions Table
•
ACL (disposition accept, drop, deny)
•
Priority/CoS
•
802.1p ToS/DCSP Stamping and Mapping (only
applies to the outer 802.1p value; cannot modify the
inner value)
•
Maximum Bandwidth
•
Maximum Depth
•
Tri-Color Marking (TCM) Rate Limiting
•
Shared (shares the bandwidth rate between rules that
specify the same maximum bandwidth action)
•
Port Redirection
•
Link Aggregate Redirection
•
No Cache (disables the logging of rule entries to the
•
hardware cache)
•
Port Disable
•
Permanent Gateway IPv4/IPv6
•
Mirror
The CLI prevents you from configuring invalid action combinations that are never allowed; however, it
does allow you to create combinations that are supported in some scenarios. For example, an action
specifying maximum bandwidth can be combined with an action specifying priority.
Use the following "Policy Action Combinations Table" together with the
Table" as a guide when creating policy actions.
Policy Action Combinations Table
Drop
N/A
Drop
No
Priority
No
Stamp/Map
No
Max BW
No
Redirect
Port
No
Redirect
Linkagg
No
Port Disable
No
Permanent
Gateway IP
page 25-32
25-43.
Stamp/
Priority Map Max BW
No No No
N/A Yes Yes
Yes N/A Yes
Yes Yes N/A
Yes Yes Yes
Yes Yes Yes
No No No
Yes Yes Yes
OmniSwitch AOS Release 7 Network Configuration Guide
"Supported Policy Actions
Redirect Redirect Port
Port Linkagg Disable
No No No
Yes Yes No
Yes Yes No
Yes Yes No
N/A No No
No N/A No
No No N/A
Yes Yes No
Configuring QoS
Permanent
Gateway IP Mirror
No Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
No No
N/A Yes
June 2013