Configuring Port Bandwidth Shaping - OmniSwitch os6900 Network Configuration Manual

Traffic Policing and Shaping
In this example, the specified ports for pgroup2 span across two slots. As a result, the maximum band-
width limit specified by the policy action is increased to 20K for all of the ports. The bandwidth limit is
increased by multiplying the number of slots by the specified bandwidth value.

Configuring Port Bandwidth Shaping

QoS supports configuring maximum bandwidth on ingress and egress ports through the
mum egress-bandwidth
tion about these commands, see the OmniSwitch CLI Reference Guide.
Note the following when configuring the ingress or egress bandwidth limit for a port:
•
Maximum bandwidth limiting is done using a granularity of 64K bps. Any value specified that is not a
multiple of 64K is rounded up to the next highest multiple of 64K.
•
The maximum bandwidth value cannot exceed the maximum bandwidth of the interface type associ-
ated with the port.
•
Modifying the maximum bandwidth is most useful for low-bandwidth links.
•
The configured port-based egress bandwidth limit takes precedence over an egress queue limit config-
ured on the same port.
page 25-28
and qos port maximum ingress-bandwidth
OmniSwitch AOS Release 7 Network Configuration Guide
Configuring QoS
qos port maxi-
CLI commands. For more informa-
June 2013