OmniSwitch os6900 Network Configuration Manual page 470

Quick Steps for Configuring BFD
3
Establish BFD sessions with all OSPF DR neighbors in full states only or with all neighbors greater
than or equal to the "2-way" state using the
interface bfd-state all-neighbors
-> ip ospf interface int1 bfd-state drs-only
-> ip ospf interface int1 bfd-state all-neighbors enable
Configuring BFD Support for BGP
1
Register BGP with the BFD protocol using the
-> ip bgp bfd-state enable
2
Enable BFD for specific BGP neighbors using the
neighbors using the ip bgp bfd-state all-neighbors
-> ip bgp neighbor 135.10.10.2 bfd-state enable
-> ip bgp bfd-state all-neighbors enable
Configuring BFD Support for VRRP Track Policies
1
Register VRRP with the BFD protocol using the
-> vrrp bfd-state enable
2
Enable BFD for a specific track policy using the
ple:
-> vrrp track 2 address 10.1.1.1 bfd-state enable
Make sure that the track policy is associated with at least one of the virtual routers. In addition, note that
the value of the address parameter should be a remote interface address. BFD cannot be configured for a
local interface address.
Note. To display the VRRP tracking policies on which BFD is enabled, use the
command.
-> show vrrp track
Track
ID
-----+-----------------------+-------------+--------+-------+--------------+
1
2
See the "VRRP Commands" chapter in the OmniSwitch CLI Reference Guide for information about the
fields in this display.
Configuring BFD Support for Static Routes
Enable BFD support for a specific static route using the
routes using the ip static-route all bfd-state
-> ip static-route 192.100.1.0/24 gateway 100.1.1.10 bfd-state enable
-> ip static-route all bfd-state enable
page 20-6
ip ospf interface bfd-state drs-only
command. For example:
Admin
Policy State
25.25.25.1 Enabled
192.10.150.42 Enabled
command. For example:
OmniSwitch AOS Release 7 Network Configuration Guide
ip bgp bfd-state command. For example:
ip bgp neighbor bfd-state
command. For example:
vrrp bfd-state command. For example:
vrrp track address bfd-state
Oper
State Pri
Down 50
Down 25
ip static-route bfd-state
Configuring BFD
command or the ip ospf
command or for all BGP
command. For exam-
show vrrp track
BFD
Status
Enabled
Enabled
command or for all static
June 2013