OmniSwitch os6900 Network Configuration Manual page 732

Configuring UNP Port-Based Access Control
To configure a default UNP for a UNP bridge port or access port, use the
command or the unp default-spb-profile
ing profile. For example, the following command assigns a default profile to bridge port 1/10 and access
port 1/12:
-> unp port 1/10 default-vlan-profile port10_unp
-> unp port 1/12 default-spb-profile service1_def_unp
The default UNP for a port is basically a "last resort" UNP for traffic that was not successfully classified
through other methods. If all other methods fail and a default UNP is not configured for the port, device
traffic is blocked on that port.
Assigning a Customer Domain ID
This implementation of UNP supports assigning UNP ports to a customer domain. A customer domain is
identified by a numerical ID value. When a port is assigned to a domain ID, only classification rules
assigned to the same domain ID are applied to traffic on these ports.
By default, all UNP ports and link aggregates are assigned to domain 0. Assigning one or more ports to a
different domain ID creates a logical group of ports to which specific classification rules are applied.
To assign a port or link aggregate to a customer domain, use the
and specify an existing domain ID number. For example:
-> unp port 1/12 unp-customer-domain 1
-> unp linkagg 5 unp-customer-domain 2
To create a new customer domain ID, use the
-> unp customer-domain 10
Use the show unp customer-domain
page 27-32
command.With both commands, specify the name of an exist-
unp customer-domain
command to display a list of existing customer domain IDs.
OmniSwitch AOS Release 7 Network Configuration Guide
Configuring Universal Network Profiles
unp default-vlan-profile
unp unp-customer-domain
command. For example:
command
June 2013