Displaying A Sflow Agent - OmniSwitch os6900 Network Configuration Manual

Diagnosing Switch Problems

Displaying a sFlow Agent

The show sflow agent
For example, to view the sFlow agent table, enter the show sflow agent command without specifying any
additional parameters. A screen similar to the following example is displayed, as shown below:
-> show sflow agent
Agent Version
Agent IP
Note. For more information about the displays that result from these commands, see the OmniSwitch CLI
Reference Guide.
Deleting a sFlow Session
To delete a sFlow receiver session, use the release form at the end of the
ing sflow receiver, followed by the receiver index and release. For example, to delete sFlow receiver
session 6, enter:
-> sflow receiver 6 release
To delete a sFlow sampler session, use the no form of the
sampler, followed by the instance ID number, the slot number of the port to delete, a slash (/), and the
port number of the port, enter:
-> no sflow sampler 1 port 2/3
To delete a sFlow poller session, use the no form of the
poller, followed by the instance ID number, the slot number of the port to delete, a slash (/), and the port
number of the port, enter:
-> no sflow poller 3 port 1/1
OmniSwitch AOS Release 7 Network Configuration Guide
command is used to display the receiver table.
= 1.3; Alcatel-Lucent; 6.1.1
= 127.0.0.1
sflow agent
sflow sampler command by entering no sflow
sflow poller command by entering no sflow
June 2013
sFlow
command by enter-
page 32-33