Configuring An Mld Static Group; Removing An Mld Static Group - OmniSwitch os6900 Network Configuration Manual

Configuring IPMSv6 on a Switch

Configuring an MLD Static Group

You can configure a port as an MLD static group by entering
the IPv6 address of the MLD static group in hexadecimal notation separated by colons, a space, followed
by vlan, a space, VLAN number (which must be between 0 and 4095), a space, followed by port, the slot
number of the port, a slash (/), and the port number.
For example, to configure an MLD static group with an IPv6 address of
-> ipv6 multicast static-group ff05::5 vlan 3 port 3/10
You can also configure a link aggregation group as an MLD static group by entering
ipv6 multicast static-group, followed by vlan, a space, VLAN number (which must be between 0 and
4095), a space, followed by port, a space, and the link aggregation group number.
For example, to configure link aggregation group 7 with designated VLAN 2 as a static group you would
enter:
-> ipv6 multicast static-group ff05::6 vlan 2 port 7

Removing an MLD Static Group

To reset the port so that it is no longer an MLD static group port, use the no form of the
ipv6 multicast static-group
address of the static group in hexadecimal notation separated by colons, a space, followed by vlan, a
space, VLAN number, a space, followed by port, a space, the slot number of the port, a slash (/), and the
port number.
For example, to remove an MLD static member with an IPv6 address of
designated VLAN 3 you would enter:
-> no ipv6 multicast static-group ff05::5 vlan 3 port 3/10
page 24-28
command by entering no ipv6 multicast static-group, followed by the IPv6
OmniSwitch AOS Release 7 Network Configuration Guide
Configuring IP Multicast Switching
ipv6 multicast static-group, followed by
enter:
ff05::5
on port 10 in slot 3 with
ff05::5
June 2013