Displaying Port Mirroring Status - OmniSwitch os6900 Network Configuration Manual

Port Mirroring
Note. Port mirroring session parameters cannot be modified when a mirroring session is enabled. Before
you can modify parameters, the mirroring session must be disabled.
To disable a port mirroring session, enter the port-mirroring command, followed by the port mirroring
session ID number and the keyword disable. The following command disables port mirroring session 6
(turning port mirroring off):
-> port-mirroring 6 disable

Displaying Port Mirroring Status

To display port mirroring status, use the
mirroring sessions, enter:
-> show port-mirroring status 6
Session Mirror
Destination
----------+----------+--------------+----------+----------+---------
1. 2/1
----------+----------+--------------+----------+----------+---------
Mirror
Source
----------+----------+--------------+----------+----------+---------
1. 1/1
1. 1/2
1. 1/3
1. 1/4
1. 1/5
Deleting A Mirroring Session
The no form of the port-mirroring
configuration between a mirrored port and a mirroring port.
To delete a mirroring session, enter the no port-mirroring command, followed by the port mirroring
session ID number. For example:
-> no port-mirroring 6
In this example, port mirroring session 6 is deleted.
Note. The port mirroring session identifier must always be specified.
page 32-22
show port-mirroring status
Mirror Unblocked
Direction Vlan
- NONE
bidirectional -
bidirectional -
bidirectional -
bidirectional -
bidirectional -
command can be used to delete a previously created mirroring session
OmniSwitch AOS Release 7 Network Configuration Guide
Diagnosing Switch Problems
command. To display all port
Config Oper
Status Status
Enable On
Enable On
Enable On
Enable On
Enable On
Enable On
June 2013