Removing Ports From A Dynamic Aggregate Group - OmniSwitch os6900 Network Configuration Manual

Configuring Dynamic Link Aggregation
All of the optional keywords listed above for this command can be entered in any order as long as they
appear after the actor admin-key keywords and their user-specified value.
For example, to configure actor administrative key of 10, a local system ID (MAC address) of
00:20:da:06:ba:d3, and a local priority of 65535 to slot 4 port 1, enter:
-> linkagg lacp port 4/1 actor admin-key 10 actor system-id 00:20:da:06:ba:d3
actor system-priority 65535
For example, to configure an actor administrative key of 10 to slot 4 port 1, enter:
-> linkagg lacp port 4/1 actor admin-key 10

Removing Ports from a Dynamic Aggregate Group

To remove a port from a dynamic aggregate group, use the no form of the
key command by entering linkagg lacp port followed by the slot number, a slash (/), and the port number.
For example, to remove port 4 in slot 4 from any dynamic aggregate group, enter:
-> no linkagg lacp port 4/4
Ports must be deleted in the reverse order in which they were configured. For example, if port 4/4 through
4/6 were configured to join dynamic aggregate group 2 you must first delete port 4/6, then port 4/5, and so
forth. The following is an example of how to delete ports in the proper sequence from the console:
-> no linkagg lacp port 4/6
-> no linkagg lacp port 4/5
-> no linkagg lacp port 4/4
OmniSwitch AOS Release 7 Network Configuration Guide
Configuring Dynamic Link Aggregate Groups
linkagg lacp agg actor admin-
June 2013 page 8-11