Quick Steps For Configuring Rip Routing - OmniSwitch os6900 Network Configuration Manual

Configuring RIP

Quick Steps for Configuring RIP Routing

To forward packets to a device on a different VLAN, you must create a router interface on each VLAN.
To route packets by using RIP, you must enable RIP and create a RIP interface on the router interface. The
following steps show you how to enable RIP routing between VLANs "from scratch". If active VLANs
and router ports have already been created on the switch, go to Step 7.
1
Create VLAN 1 with a description (e.g., VLAN 1) by using the
-> vlan 1 name "VLAN 1"
2
Create VLAN 2 with a description (e.g., VLAN 2) by using the vlan command. For example:
-> vlan 2 name "VLAN 2"
3
Assign an active port to VLAN 1 by using the
following command assigns port 1 on slot 1 to VLAN 1:
-> vlan 1 members port 1/1 untagged
4
Assign an active port to VLAN 2 by using the vlan members command. For example, the following
command assigns port 2 on slot 1 to VLAN 2:
-> vlan 2 members port 1/2 untagged
5
Configure an IP interface to enable IP routing on a VLAN by using the
example:
-> ip interface vlan-1 address 171.10.1.1 vlan 1
6
Configure an IP interface to enable IP routing on a VLAN by using the ip interface command. For
example:
-> ip interface vlan-2 address 171.11.1.1 vlan 2
7
Load RIP into the switch memory by using the
-> ip load rip
8
Enable RIP on the switch by using the
-> ip rip admin-state enable
9
Create a RIP interface on VLAN 1 by using the
-> ip rip interface vlan-1
10
Enable the RIP interface by using the
-> ip rip interface vlan-1 admin-state enable
11
Create an RIP interface on VLAN 2 by using the ip rip interface command. For example:
-> ip rip interface vlan-2
Note For more information on VLANs and router ports, see
.
OmniSwitch AOS Release 7 Network Configuration Guide
vlan members untagged
ip load rip command. For example:
ip rip admin-state command. For example:
ip rip interface
ip rip interface admin-state
Chapter 4, "Configuring VLANs."
June 2013
Quick Steps for Configuring RIP Routing
vlan command. For example:
command. For example, the
ip interface command. For
command. For example:
command. For example:
page 19-3