Multiport Aggregate Device Installation; Prerequisites To Multiport Aggregate Device Installation - Nortel Passport 15000 Hardware Installation And Maintenance

186 Chapter 13 Peripheral equipment

Multiport aggregate device installation

Prerequisites to multiport aggregate device installation

Multiport aggregate device installation task flow
241-1501-240 5.2S2
Install a multiport aggregate device to break out the ports of a 32-port E1
TDM FP.
• "Prerequisites to multiport aggregate device installation" (page 186)
• "Multiport aggregate device installation task flow" (page 186)
• You must be familiar with "Safety considerations and best practices"
(page 53).
• You will need a multiport aggregate devices with one of the following
PECs:
— NT0486 for the balanced
— NT0421 for the unbalanced
• The multiport aggregate device installs in a 19-inch rack or requires one
pair of the adapter brackets from kit NTHW14 to be installed in a NEBS
2000 frame.
This task flow shows the sequence of procedures you do to install a multiport
aggregate device. To link to any procedure, go to "Task flow navigation"
(page 189).