Starting System - TGB blade 300 Service Manual

17. ELECTRICAL SYSTEM

Starting System

Starting circuit diagram
Change switch
Inspection on starter relay
Open the main switch.
Press the brake.
Push down the starter switch.
If a sound of "Looh Looh" is heard, it indicates the
relay function normally.
Remove the seat.
Disconnect the negative cable terminal of the
battery.
Disconnect the cable positive terminal from the
relay.
Disconnect the positive cable of the starter motor.
Disconnect the coupler of the relay.
Connect an ohmmeter to the large terminal end.
Connect the yellow/red cable to the battery positive
terminal and the yellow/black cable to the battery
negative terminal.
Check the continuity of the large terminal end. If
there is no continuity, replace the relay.
17-10
PDF created with pdfFactory Pro trial version
To this chapter contents
Shift gear
control unit
BR/Y
G/W
G
G/R
F
N
R
Y/B
B Black
R Red
G Green
W White
Y Yellow Starter switch
BR Brown
W/B
Brake
switch
G/Y
Starter relay
Y/R
G/Y
www.pdffactory.com
Fuse 15A
B
R
Main switch
Main fuse
Battery
Starter motor
G
Brake light
Starter relay
30A