Float Chamber - TGB blade 300 Service Manual

Float Chamber

Disassembly
Remove 3 mounting screws(4 mounting
screws) and remove float chamber cover.
Remove the fuel level plate, float pin, float and
float valve.
Inspection
Check float valve and valve seat for damage,
blocking.
Check float valve for wearing, and check valve
seat face for wear, dirt.
Caution
In case of worn out or dirt, the float valve and
valve seat will not tightly close causing fuel level
to increase and as a result, fuel flooding. A worn
out or dirty float valve must be replaced with a
new a new one.
PDF created with pdfFactory Pro trial version
To this chapter contents
3 screws(250C.C.)
Float
Fuel level plate
Float
Check for wear or damage
www.pdffactory.com
4. FUEL SYSTEM
4 screws(300C.C.)
Float valve
Pin
Pin
Float valve
4-7