TGB blade 300 Service Manual page 97

With 4~5g grease spreads wipes drives in the
movable drive face axis hole.
Install drive face boss.
Caution
The movable drive face surface has to be free of
grease. Clean it with cleaning solvent.
Install movable drive face comp. onto crankshaft.
Driven pulley installation
Press drive belt into pulley groove, and then pull
the belt onto drive shaft.
Install drive face, washer and nut.
Caution
Make sure that two sides of pulley surfaces have
to be free of grease.
solvent.
Hold drives face with universal holder.
Tighten nut to specified torque.
Torque value: 8.5~10.5kgf-m
Install left crankcase cover.
PDF created with pdfFactory Pro trial version
To this chapter contents
Clean it with cleaning
www.pdffactory.com
8. V-BELT DRIVING SYSTEM
Movable drive face
Crank shaft
Press down
Drive belt
Drive face boss
Drive face boss
8-9