TGB blade 300 Service Manual page 191

Right footrest side – rear brake master cylinder
B
Place a container under the brake master cylinder,
remove fluid hose clamp, and drain out the brake
fluid.
Loosen the brake hose bolt and finally remove the
brake hose.
Remove the clip, and remove brake push rod pin.
Remove the master cylinder socket bolts and the
master cylinder.
Disassembly
Remove the rubber boot.
Remove the cir clip.
Remove the piston and the spring.
Clean the master cylinder with recommended
brake fluid.
Master Cylinder Inspection
Check the master cylinder for damage or scratch.
Replace it if necessary.
Measure the cylinder inner diameter at several
points along both X and Y directions.
Replace the cylinder if the measured values
exceed allowable limit.
Allowable limit:
Hand brake 14.050 mm
Foot brake 15.950 mm
PDF created with pdfFactory Pro trial version
To this chapter contents
16. REAR BRAKE & REAR WHEEL & REAR CUSHION
www.pdffactory.com
Cir clip
Rubber boot
Piston
Piston cup
Spring
Master cylinder
16-15