Starting Clutch - TGB blade 300 Service Manual

To this chapter contents
10. ALTERNATOR/STARTING CLUTCH
Remove starter reduction gear and shaft. Pull
flywheel puller
out flywheel with A.C.G. flywheel puller.
Special tool:
A.C.G. Flywheel puller
Remove flywheel and starting driven gear.

Starting Clutch

ID
Starting Clutch Inspection
Remove starting clutch driven gear.
Check the gear for wear or damage.
Measure the ID and OD of the starting clutch
driven gear.
Service Limit: ID: 25.050 mm
OD: 42.100 mm
OD
Check the starting reduction gear and shaft for
wear or damage.
Check each roller for wear or damage.
10-5
PDF created with pdfFactory Pro trial version www.pdffactory.com