A.c.g. Set Installation; Right Crankcase Cover Installation - TGB blade 300 Service Manual

10. ALTERNATOR/STARTING CLUTCH
Install reduction gear shaft and reduction gear.

A.C.G. Set Installation

Install the A.C.G. coil set onto right crankcase
cover (3 screws).
Install pulse generator (2 screws).
Tie the wire harness securely onto the indent of
crankcase.
Caution
Make sure that the wire harness is placed under
pulse generator.

Right Crankcase Cover Installation

Install dowel pin and new gasket.
Remove water pump cover.
Install right crankcase cover onto the crankcase.
Note: Align the water pump shaft indent with the oil
pump shaft.
10-8
PDF created with pdfFactory Pro trial version
To this chapter contents
Dowel pin
www.pdffactory.com
Reduction gear
Wire
2 bolts
3 screws