Steering Tie-Rod - TGB blade 300 Service Manual

To this chapter contents
15. STEERING / FRONT SUSPENSION

Steering Tie-Rod

Remove
Remove cotter pin and tie-rod nut from steering
shaft side.
Remove cotter pin and tie-rod nut from wheel side.
Inspection
Inspect the tie-rod for damage or bending. Inspect
the ball joint rubbers for damage , wear or
deterioration.
Turn the ball joints with fingers. The ball joints
should turn smoothly and quietly.
Ball joint
Installation
Install the ball joint with "adjustment groove" on
the wheel side.
Install tie-rod nuts, and tighten the nuts.
Torque value: 5.0kgf-m
After tightened the tie-rod nut, install the cotter pin.
Adjustment groove
15-6
PDF created with pdfFactory Pro trial version www.pdffactory.com