TGB blade 300 Service Manual page 132

11. CRANKCASE / CRANK
Clean the crankshaft.
Apply a layer of grease on the lip of oil seal, Puts
on the left crank shaft.
Install the oil seal in the left crankcase with care
not to damage the lip of the oil seal.
By oil seal driver (27×42×7), oil seal will knock into
located.
Special tool:
Oil seal driver (27×42×7)
Install the tensioner and tighten the pivot bolt.
Torque value: 0.8 ~1.2kgf-m
Install the cam chain.
Install the cam chain setting plate.
11-8
PDF created with pdfFactory Pro trial version
To this chapter contents
Tensioner
www.pdffactory.com
Oil
seal
driver
Cam chain setting plate