TGB blade 300 Service Manual page 201

Inspection on regulator rectifier
Remove the seat, rear carrier and rear fender.
Disconnect two 3 pin couplers of the regulator
rectifier.
Inspection the rectifier coupler to the wire harness
passes the condition.
Item
Main switch
connection
Battery
connection
Charging coil
If the readings measured are not normal, check
parts in the circuit.
If the parts are normal, then trouble is in the wiring. If
there is nothing wrong with parts and wiring, replace
the regulator rectifier.
PDF created with pdfFactory Pro trial version
To this chapter contents
Check Points Standard Value
Battery voltage
R – B
(ON)
R – G
Battery voltage
Y – Y
0.17 ~ 0.8Ω
17. ELECTRICAL SYSTEM
www.pdffactory.com
17-7