TGB blade 300 Service Manual page 100

8. V-BELT DRIVING SYSTEM
Clutch weight Replacement
Remove snap ring and washer, and then remove
clutch weight and spring from driving plate.
Caution
Some of models are equipped with one mounting
plate instead of 3 snap rings.
Check if spring is damage or insufficient elasticity.
Check if shock absorption rubber is damage or
deformation.
Apply with grease onto setting pins.
Install new clutch weight onto setting pin and then
push to the specified location.
Apply with grease onto setting pins.
But, the clutch block should not be greased. If so,
replace it.
Caution
Grease or lubricant will damage the clutch weight
and affect the block's connection capacity.
Install the spring into groove with pliers.
8-12
PDF created with pdfFactory Pro trial version
To this chapter contents
Replace it if necessary.
Spring
Clutch weight
Shock absorption rubber
Shock absorption rubber
Clutch weight
Spring
www.pdffactory.com
Driving plate
Snap ring
Setting pin