Lighting System, Instruments; Setting Kilometers Or Miles; Adjusting The Shift Speed Rpm 1; Adjusting The Shift Speed Rpm 2 - KTM 125 Duke 2013 Repair Manual

15

LIGHTING SYSTEM, INSTRUMENTS

15.1

Setting kilometers or miles

Info
Make the country-specific setting.
15.2

Adjusting the shift speed RPM 1

15.3

Adjusting the shift speed RPM 2

Condition
The ignition is on.
The motorcycle is stationary.
–
Press the MODE button briefly and repeatedly until ODO appears on the display.
–
Press the MODE button for 5 - 10 seconds.
The display changes from km/h to mph or from mph to km/h.
401303-01
Condition
The ignition is on.
The motorcycle is stationary.
–
Press the MODE button briefly and repeatedly until TRIP 2 appears on the display.
–
Press the MODE button for 5 - 10 seconds.
The display RPM 1 appears.
Info
The engine speed can be set at intervals of 50.
RPM 1 is the engine speed above which the shift warning light starts to
flash.
–
Set the speed with the MODE and SET buttons.
401307-01
Info
The MODE button increases the value.
The SET button decreases the value.
–
Do not activate the two buttons for approx. 15 seconds.
The display RPM 1 goes out and the set speed is stored.
Condition
The ignition is on.
The motorcycle is stationary.
–
Press the MODE button briefly and repeatedly until TRIP 2 appears on the display.
–
Press the SET button for 5 - 10 seconds.
The display RPM 2 appears.
Info
The engine speed can be set at intervals of 50.
RPM 2 is the engine speed above which the shift warning light lights up con-
stantly.
The speed RPM 2 must always be higher than the speed RPM 1.
401308-01
–
Set the speed with the MODE and SET buttons.
Info
The MODE button increases the value.
The SET button decreases the value.
94