MAINTENANCE WORK ON CHASSIS AND ENGINE
Setting the fork offset
x
11.27
Removing the fork legs
11.28
Installing the fork legs
x
11.29
(250 XCF‑W USA)
–
Remove the lower triple clamp.
–
Remove screw
–
Clean the parts and check for damage.
–
Rotate the steering stem 180° and insert into the triple clamp. Mount and tighten
screw
Guideline
Screw, bottom steering
head
–
Install the lower triple clamp.
500104-10
–
Remove the front wheel.
–
Remove screws
–
Remove cable clip
–
Remove screws
–
Hang the brake caliper and the brake line loosely to the side.
500093-10
(250 XCF‑W USA)
–
Loosen screw
–
Loosen screw
500094-10
(250 EXC-F EU)
–
Loosen screw
–
Loosen screw
100023-11
–
Position the fork legs.
Info
The uppermost groove in the fork leg must be flush to the upper edge of the
upper triple clamp.
Position the bleeder screw
100021-10
(
x
. Remove the steering stem.
.
M20x1.5
x
(
(
p. 64)
x
and take off clamp.
.
and take off brake caliper.
. Remove the fork leg on the left.
. Remove the fork leg on the right.
. Remove the fork leg on the left.
. Remove the fork leg on the right.
to the front.
p. 44)
60 Nm
Loctite
(44.3 lbf ft)
p. 46)
42
®
243™