12.10
Installing the fork legs
Main work
–
Remove screws
–
Remove the cable tie.
–
Remove screws
–
Allow the brake caliper and the brake line to hang loosely to
the side.
K00545-10
–
Loosen screws
–
Loosen screws
W00341-10
Main work
–
Position the fork legs.
Bleeder screws
Info
Grooves are milled into the side of the upper end of the
fork legs. The second milled groove (from the top) must
be flush with the upper edge of the upper triple clamp.
The pressure and rebound damping is located in the
left and right fork leg.
W00297-11
(All EXC-F, XW-F)
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Tighten screws
Guideline
Screw, bottom
W00341-11
triple clamp
(All special models)
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Tighten screws
Guideline
Screw, bottom
triple clamp
SERVICE WORK ON THE CHASSIS 12
1
and take off the clamp.
2
and take off the brake caliper.
3
. Take out the left fork leg.
4
. Take out the right fork leg.
1
are positioned toward the front.
2
.
M8
3
.
M8
2
.
M8
3
.
M8
20 Nm
(14.8 lbf ft)
15 Nm
(11.1 lbf ft)
17 Nm
(12.5 lbf ft)
12 Nm (8.9 lbf ft)
63