Ford 2002 Bantam Workshop Manual page 1651

501-20B-60
GENERAL PROCEDURES (CONTINUED)
08/2001
Occupant Restraints — Passive — Supplemental Air
Bag System
Two stage air bag modules
4. CAUTION: Do not connect both test
leads to the adapter. Both air bag
module inflators must be deployed
separately.
Connect two test leads to the air bag
module and the other end of one of the test
leads to the adapter (driver air bag module
shown).
All air bag modules
5. CAUTION: To protect the test lead
electrical connector(s) from damage
during deployment, raise the air bag
module off the ground on two
wooden blocks.
Place the air bag module inside a suitable
rigid wire cage with the air bag module
cover uppermost.
6. Connect the deployment lead to the
adapter.
7. WARNING: Before proceeding make
sure that all personnel in the vicinity
are aware that a loud noise (bang) is
about to occur. Do not let anybody
approach closer than six meters.
Failure to follow this instruction may
result in personal injury.
Move as far away as possible from the air
bag module and connect the deployment
lead to the battery.
501-20B-60
2002 Bantam