Component
Hot Tank Factory Set Point
85°C (185°F)
Replacement parts can be obtained from Waterlogic or an Authorized Waterlogic Dealer.
See Parts Layouts, Drawings, and Lists for additional repair parts.
Sanitizing
Sanitization must be performed at least once a year to eliminate any potential microbiological
contaminates. See Sanitizing Instructions in the Pre‐Installation section of this manual.
Hot Tank Service
Hot Tanks (with controls) must be replaced at least every 3‐5 years depending on usage. Descaling
hot tank may be required on a regular basis depending upon filtration and local water conditions.
See Hot Tank Descaling Instructions Section of this manual.
NOTE:
At the end of this product's life, ensure that it is disposed of in an environmentally friendly manner
which is fully compliant with all Federal/State/Local Requirements and Guidelines.
WL100 Operating, Installation, and Service Manual Page 24 Revision: 5‐20‐2016
REPLACEMENT COMPONENTS
Part No.
Frequency of Replacement
Replace every 3‐5 years depending on
HT‐3041
usage.
WLCP Part No. 12‐5615