WaterLogic WL100 Operating, Installation And Service Manual page 20

6. Remove the Hot and Cold water supply lines from the inlet line solenoids.
7. Disconnect tank line outlet lines from Hot and Cold solenoids to drain into basin or bucket.
8. Turn outlet fittings outward to avoid water spilling onto the Compressor.
9. Reconnect Tubing into Outlet Elbows once drained.
10. Dry inside of Bottom Tray as necessary.
11. Replace Lower Front Panel
WL100 Operating, Installation, and Service Manual Page 20 Revision: 5‐20‐2016