WaterLogic WL100 Operating, Installation And Service Manual page 49

CHANGING HOT WATER MODE TO AMBIENT WATER
The WL100 Water Treatment System comes with set to Hot / Cold, which can be changed to
Ambient / Cold settings. On the
Pins 2 and 3.
Unplug Power Cord and remove top cover to access Energy Saver PCB.
Energy Saver PCB – P/N EN‐6131 – WLCP PN 20‐0075
The WL100 Water Treatment System comes with Hot
and Cold Water factory settings.
PCB Jumper JP9 in positions ‐ Pin 1 and 2
Change to Ambient and Cold by moving PCB Jumper
JP9 to positions – Pin 2 and 3
WL100 Operating, Installation, and Service Manual Page 49 Revision: 5‐20‐2016
Energy Saver PCB,
Move the Jumper on JP9 from Pins 1 and 2 to
1 2
2
Pin Numbers
1 2 3
3