Replacement Components - WaterLogic WL400 Service Manual

Component
UV Light, 13 Watts
Spiral
Hot Tank 185°F (85°C)
Sediment Filter
Pre‐Carbon Filter
RO Membrane Replacement Kit
Post Carbon Filter
* One pre‐installed. One required for NSF‐53 and NSF P231 Certification.
Replacement parts can be obtained from Waterlogic or an Authorized Waterlogic Dealer.
See Parts Layouts, Drawings, and Lists for additional repair parts.
Hot Tank Service
Hot Tanks (with controls) must be replaced at least every 3‐5 years depending on usage. Descaling
hot tank may be required on a regular basis depending upon filtration and local water conditions.
See Service Section.
NOTE:
At the end of this product's life, ensure that it is disposed of in an environmentally friendly manner
which is fully compliant with all Federal/State/Local Requirements and Guidelines.
WL400 Manual Page 24 – Revision: 5‐2‐2018
REPLACEMENT COMPONENTS
WLCP PN Frequency of Replacement
Every 6 months, or as required
10‐8075
Part No CT‐2090‐A
Clean every 12 months, replace as needed
10‐8080
Part No ‐0007‐A
Replace every 3‐5 years depending on
HT‐3037‐A usage
Part No HT‐3037‐A
Every 6‐months, or as required. Local
water conditions will determine proper
10‐8050
filter type and maintenance schedule.
Part No. RO‐0001‐A
Every 6‐months, or as required. Local
water conditions will determine proper
10‐8055
filter type and maintenance schedule. Part
No. RO‐0002‐A
Every 6‐months, or as required. Local
10‐8061 water conditions will determine proper
filter type and maintenance schedule.
Every 6‐months, or as required. Local
water conditions will determine proper
10‐8065
filter type and maintenance schedule.
Part No. RO‐0005‐A