WaterLogic WL100 Operating, Installation And Service Manual page 51

1. Red Heater and Compressor Power Switch won't light and the Red LED on the
Front won't light
2. Red Power Switch is lit but the red LED on the Front is not lit
3. Compressor Runs but does Not Chill
4. Compressor is Not Running
Red Heater and Compressor Power Switch won't light and the Red LED on the Front
won't light
Possible Reason
Circuit Breaker
Fuse is Blown
Defective / Loose Power Cord
Failed Power Line Noise Filter,
ElectroMagnetic Interference
filter (EMI)
Defective Red Heater /
Compressor Switch
WL100 Operating, Installation, and Service Manual Page 51 Revision: 5‐20‐2016
POWER TROUBLESHOOTING INDEX
Check the Circuit Breaker
Replace Fuse
Check that power cord is properly plugged in. If it is properly
plugged in, use a different power cord to verify.
Replace EMI
Replace Red Heater / Compressor Switch
Solution