Replacement Components - WaterLogic WL400 Operating, Installation And Service Manual

Component
UV Light, 15 Watts
Spiral
Hot Tank 189°F (87°C)
Sediment Filter
Pre-Carbon Filter
RO Membrane Replacement Kit NA
Post Carbon Filter
* One pre-installed. One required for NSF-53 and NSF P231 Certification.
Replacement parts can be obtained from Waterlogic or an Authorized Waterlogic Dealer.
See Parts Layouts, Drawings, and Lists for additional repair parts.
Hot Tank Service
Hot Tanks (with controls) must be replaced at least every 5 years. Descaling hot tank may be
required on a regular basis depending upon filtration and local water conditions. See Service Section.
NOTE:
At the end of this product's life, ensure that it is disposed of in an environmentally friendly manner
which is fully compliant with all Federal/State/Local Requirements and Guidelines.
WL400 Operating, Installation, and Service Manual

REPLACEMENT COMPONENTS

Part No. Frequency of Replacement
Every 6 months, or as required
CT-2090-A
WLUSA Part No 10-8075
Clean every 12 months, replace as needed
FU-0007-A
WLUSA Part No 12-8080
Replace every 5 years
HT-3041
WLUSA Part No 12-5615
Every 6-months, or as required. Local
water conditions will determine proper
RO-0001-A
filter type and maintenance schedule.
WLUSA # 10-8050
Every 6-months, or as required. Local
water conditions will determine proper
RO-0002-A
filter type and maintenance schedule.
WLUSA # 10-8055
Every 6-months, or as required. Local
water conditions will determine proper
filter type and maintenance schedule.
WLUSA # 10-8061
Every 6-months, or as required. Local
water conditions will determine proper
RO-0005-A
filter type and maintenance schedule.
WLUSA # 10-8065
Page 37 - Revision: 5-29-2015