WaterLogic WL100 Operating, Installation And Service Manual page 48

6. For demonstrative purposes, photos below have lowered the hot tank from the unit.
Press the reset button
7. Reattach the Protective Metal Box by depressing the top
flap of the Protective Metal Box so it snaps back into its
original position on the hot tank.
8. Replace the Lower Front Panel.
9. Plug in the Power Cord.
10. Turn on the Red Compressor/Heater Switch I=ON position
The Hot and Cold tanks must be filled with water BEFORE turning on the
Red Heater and Compressor Switch.
11. Verify the cooler is fully operational before installing it at the customers' site.
WL100 Operating, Installation, and Service Manual Page 48 Revision: 5‐20‐2016