Replacement Components - WaterLogic WL500 – Sparkling Operating, Installation And Service Manual

Hide thumbs Also See for WL500 – Sparkling:

Manual (82 pages)

Operating, installation and service manual (53 pages)

Quick start manual (14 pages)

Table Of Contents

Table of Contents

Component

UV Light, TUV-8W

UV Quartz Sleeve

10" Twist Carbon Block Filter,

1-Micron, Reverse-Threaded

10" Twist GAC filter, with

Polyphosphate Additive to

Reduce Scaling, Reverse-

Threaded

Replacement parts can be obtained from Waterlogic or an Authorized Waterlogic Dealer.

See Parts Layouts, Drawings, and Lists for additional repair parts.

Hot Tank HT-3021 Service

Hot Tank (with controls) must be replaced at least every 5 years.

Descaling hot tank may be required on a regular basis depending

upon filtration and local water conditions. See Service Section.

Hot Tank Assembly Part Number is HT-3021 (INN# 10-7082)

Sparkling Chamber Level Sensor Probe Assembly CT-2023

WL500 Sparkling chamber has a level sensor probe that needs to be

maintained and descaled at every filter change. Replace if needed.

Level Sensor Probe Part Number is CT-2023-A (INN# 10-7250)

NOTE:

WL500 comes with filtration pre-installed in the unit. Filters must

be rinsed before use. Never rinse through the WL500.

Filters may need to be modified or supplemented to best match

local water conditions. WL500 Filters are reverse thread and

a filter must be engaged in the 1

shut-off-valve and allow water to pass to the inlet solenoid.

See Installation Procedures and Filter By-Pass Instructions.

NOTE:

At the end of this product's life, ensure that it is disposed of

in an environmentally friendly manner which is fully compliant

with all Federal/State/Local Requirements and Guidelines.

Waterlogic CO

35-45 psi, single output pressure gauge, inline shut-off valve, ¼ quick

connect fitting, safety relief, and CO

Revision 1.1