CHANGING HOT WATER MODE TO AMBIENT WATER
All WL100 Water Treatment Systems have factory setting to Hot and Cold, which can be changed
to Ambient and Cold Water settings.
Unplug Power Cord and remove Top Cover to access Energy Saver PCB.
On the
Energy Saver PCB,
Energy Saver PCB – P/N EN‐6131 – WLCP PN 20‐0075
The WL100 Water Treatment System comes with
Hot and Cold Water factory settings.
PCB Jumper JP9 in positions ‐ Pin 1 and 2
Change to Ambient and Cold by moving PCB
Jumper JP9 to positions – Pin 2 and 3
WL100 Operating, Installation, and Service Manual Page 12 Revision: 5‐20‐2016
PROGRAMMING INSTRUCTIONS
Move the Jumper on JP9 from Pins 1 and 2 to Pins 2 and 3.
Pin Numbers
1
1
2
2
3
2
3